Hi @IKS. I don't think I have enough info for you, but here's what comes up once the Raspberry Pi is turned on.
Net: No ethernet found.
starting USB...
USBO: Core Release: 2.80a
scanning bus 0 for devices... 3 USB Devices(s) found
scanning usb for storage devices... 0 Storage Device(s) found
autoboot in 1 seconds, enter stop to stopswitch to partitions #0, OK
mmc0 is current device
Scanning mmc 0:1...
Found U-Boot script /boot.scr.uimg
reading /boot.scr.uimg
401 bytes read in 15ms (25.4 KiB/s)
## Executing script at 02000000
reading zImage
7395304 bytes read in 397 ms (17.8 MiB/s)
reading ramdisk.uimg
1545816 bytes read in 102 ms (14.5 MiB/s)
Kernal image @ 0x1000000 [ 0x000000 - 0x70d7e8 ]
## Loading init Ramdisk from Legacy Image at 02100000 ...
Image Name:
Image Type: ARM Linux RAMDisk Image (gzip compressed)
Data Size: 1545752 Bytes = 1.5 MiB
Load Address: 00000000
Entry Point: 00000000
Verifying Checksum ... OK
## Flattened Device Tree blob at 2effb400
Booting using fdt blob at 0x2effb400
reserving fdt memory region: addr=0 size=1000
Using Device Tree in place at 2effb400, end 2f002fbe
Starting kernel...
After the "Starting kernel..." my monitor hooked up to the Raspberry Pi loses it's signal and just goes black. I hope this is enough to help fix the issue. Let me know if I can do anything else for you.
