Raspberry Pi 3 b+ no boot

TonyEvo

Hi guys.
I have a big problem in the Emteria boot.
I tried more installers (and more versions of Emteria, 1.0.0.9 and 0.81), I tried more SD cards, I tried more operating systems, but my Raspberry PI 3 B +, fails to boot the GUI, remains locked for hours on the black screen.
the problem is this
https://youtu.be/t2xH7wTZWwo

or this

TonyEvo

the problem is the versions higher than 0.7. with the 0.7 it works

IKS

If you are using the official screen, it might be related to #831

But your device is also complaining about USB current change. You should check your power supply.

cemoi71

@TonyEvo do you know which size were used on the 0.7?
Did you tried the v0.8.1?
For my case the 0.8.1 didn't directly, i don't know why but only after a week it worked. I tried each day to power-on at last one time, and saw no gui but was reachable per adb (not ssh). As a i told it worked then after a week with 1280x720 and not the official size (by changing on it it wasn't fine like the 1280x720).

TonyEvo

@IKS said:
If you are using the official screen, it might be related to #831

But your device is also complaining about USB current change. You should check your power supply.

yes, I have the official 7 "screen.
I'm doing the tests with a 2.5A power supply, but I don't think it's a power problem, because the problem with the 0.7 is not there and all the other distros work.

TonyEvo

@cemoi71 said:
@TonyEvo do you know which size were used on the 0.7?
Did you tried the v0.8.1?
For my case the 0.8.1 didn't directly, i don't know why but only after a week it worked. I tried each day to power-on at last one time, and saw no gui but was reachable per adb (not ssh). As a i told it worked then after a week with 1280x720 and not the official size (by changing on it it wasn't fine like the 1280x720).

0.8 doesn't work for me, but I don't know how the screen is set to 0.7

cemoi71

@IKS may i ask you how it works on your side with the rpi and its official display?