Emteria NOT booting

Charlie

Rasp 3B+, 32Gig SD card burned thru installer with (?) no errors in the log file ,insertion to the Rpi starts to run with error reportings , gets to the point of " Starting kernel..." then no advance.
????
The message on screen as follows

          "  Net:  No ethernet found.
             boot in 1 seconds, enter 'no' to stopswitch to partion#0,OK
             mmc0 is current device
             Scanning mmc 0:1...
             Found U-Boot script /boot.scr.uimg
             991 bytes read in 1 ms(967.8 KiB/s)
             ## Executing script at 02400000
             The address of the fdt is invalid (NULL)
             No FDT memory address is configured. Please configure
             the FDT address via " fdt addr <address>" command.       ## ( "  HOW " ??????) ##
             Aborting!
             ** Unrecognised filesystem type **
             ## Warning: defaulting to text format
             ## Info: input data size =181 =0xB5
             2368094 bytes read in 102 ms (22.1 MiB/s)
             9454432 bytes read in 405 ms (22.3MiB/s)
             Kernel image @ 0x080000 [ 0x000000 _ ox904360 ]
             ## Loading init Ramdisk from Legacy Image at 02700000...
             Image Name:
             Image Type: ARM Linux Ramdisk Image ( gzip compressed)
             Data Size :       2368030 Bytes = 2.3 MiB
             Load Address : 00000000
             Entry Point :     00000000
             Verifying Checksum ... OK
             Starting Kernel ...

                                             "        and that's IT ????????  

  can you please advise me on how to set this up 

                                                                with thanks.... C. :s 

Jan_Kehren

Hey @Charlie,

here is an article in our Knowledge Base on how to set up UART on RPi https://emteria.com/kb/connect-uart-rpi please provide a full log

Charlie

Hi @Jan, thanks .....late night here 'downunder' . I'll get onto it in the (my) morning and forward the logs. Appreciative of your assistance. C.

Charlie

Hi @Jan_Kehren ,
setup as directed , the serial output from Putty is unfortunately te same as on the monitor . File attached.

Charlie

Hi @Jan_Kehren , if these my help I include the Emteria_download log , cmdline .file and the config.file

.....C.

smieschek

@Charlie Hi Charlie, I think you have flashed the Distec Artista-IoT image, which is a different device than the RPi3 and therefore it doesn't boot. In the emteria installer you can select the device, chose RPi3:

Charlie

DUH ! palm smack.

thanks so much for your assistance @smieschek , time to play.
A little display overscan but looks great ! Thanks again C.