djw0bbl3

About

Username
djw0bbl3
Joined
Visits
61
Last Active
Roles
Member

Comments

  • Thank you so much! Hopefully this should be the key ingredient Any more news on the RPi Kernel?
  • Hi Kalkov, Is there any chance you could point me towards some documentation on how I can replace the kernel with one that has /dev/mem enabled? Thanks
  • Hi Kalkov, I am still working on this and I was reading online about a similar problem encountered `https://community.nxp.com/thread/450382' Am I right in saying that /dev/mem presence is disabled in the kernel config? In this case would recompil…
  • That's not a problem! If you have any suggestions or ideas about how I can progress with the task I would love to hear. I've put quite a lot of work into this so it would be a shame to not be able to finish working on it and get it out to the commun…
  • Hi again, long time no speak. So I am still working with the module and I still have not had any breakthroughs. I have created a dtbo for the device using the dts file provided on their git "https://github.com/pimoroni/hyperpixel4" and I have the go…
  • Apologies for the questions but as this seems to be an "included" driver rather than a loadable .ko, could I just go ahead and replace the kernel? If so, is there a specific .config I could use to ensure that all the necessary libraries and drivers …
  • So I had it compile successfully which is great! But I noticed that a loadable .ko had not been created, as I did not select the GT9XX driver with an 'm' symbol. So I started again but the config refused to let me... only letting me include it with …
  • I have the kernel compiling at the moment... had it run through but stupidly didn't select the goodix driver in the config menu before compiling... also I am right in saying that Emteria is 32-bit? If this is to be successful I am confident that the…
  • Which toolchain do you advise to use for building the kernel? downloaded the latest ndk but its missing GCC in the toolchain... not sure how to proceed on this. Any help would be appreciated!
  • Been fooling around all morning trying to find a kernel to use for this! Thank you very much for pointing me to this, didn't seem to get a forum notification. I am making progress and hope to have the driver installed for when the display arrives. M…
  • Also it might be worth adding that I have direct contact with the software developers over at Pimoroni. I think it would be great for the Emteria Platform if we could get this display supported!
  • No Problem! I have a further development and I am going to try and configure a Pimoroni HyperPixel 4.0 display (https://shop.pimoroni.com/products/hyperpixel-4?variant=12569485443155&gclid=Cj0KCQiAzKnjBRDPARIsAKxfTRDiECuaDbVTgmJdw0Q3JzmmSMMz5B27…
  • Hi again, Unfortunately I have some bad news. The DFRobot display listed above is no longer in stock, so I won't be able to order it for the project. A real kick in the teeth to be honest. This is an issue for me as I have a lot of different thi…
  • Hi Igor, Thank you very much for the response. I think I will go ahead and order the part, as it fits the specifications for what I want out of the design. Thank you also for referring me to this documentation, hopefully their shouldn't be an issue …
  • Thank you very much for the reply. I would like to follow through with this task, but I am a little unsure of the configuration steps that are required. I am not so much a beginner when it comes to Linux, but could you maybe provide me with a couple…