Emteria NOT booting
Rasp 3B+, 32Gig SD card burned thru installer with (?) no errors in the log file ,insertion to the Rpi starts to run with error reportings , gets to the point of " Starting kernel..." then no advance.
????
The message on screen as follows 
" Net: No ethernet found.
boot in 1 seconds, enter 'no' to stopswitch to partion#0,OK
mmc0 is current device
Scanning mmc 0:1...
Found U-Boot script /boot.scr.uimg
991 bytes read in 1 ms(967.8 KiB/s)
## Executing script at 02400000
The address of the fdt is invalid (NULL)
No FDT memory address is configured. Please configure
the FDT address via " fdt addr <address>" command. ## ( " HOW " ??????) ##
Aborting!
** Unrecognised filesystem type **
## Warning: defaulting to text format
## Info: input data size =181 =0xB5
2368094 bytes read in 102 ms (22.1 MiB/s)
9454432 bytes read in 405 ms (22.3MiB/s)
Kernel image @ 0x080000 [ 0x000000 _ ox904360 ]
## Loading init Ramdisk from Legacy Image at 02700000...
Image Name:
Image Type: ARM Linux Ramdisk Image ( gzip compressed)
Data Size : 2368030 Bytes = 2.3 MiB
Load Address : 00000000
Entry Point : 00000000
Verifying Checksum ... OK
Starting Kernel ...
" and that's IT ????????
can you please advise me on how to set this up
with thanks.... C. :s
0
This discussion has been closed.
Comments
Hey @Charlie,
here is an article in our Knowledge Base on how to set up UART on RPi https://emteria.com/kb/connect-uart-rpi please provide a full log
Hi @Jan, thanks .....late night here 'downunder' . I'll get onto it in the (my) morning and forward the logs. Appreciative of your assistance. C.
Hi @Jan_Kehren ,
setup as directed , the serial output from Putty is unfortunately te same as on the monitor . File attached.
Hi @Jan_Kehren , if these my help I include the Emteria_download log , cmdline .file and the config.file
.....C.
@Charlie Hi Charlie, I think you have flashed the Distec Artista-IoT image, which is a different device than the RPi3 and therefore it doesn't boot. In the emteria installer you can select the device, chose RPi3:
DUH ! palm smack.
thanks so much for your assistance @smieschek , time to play.
A little display overscan but looks great ! Thanks again C.